H3C Technologies H3C S3100 Series Switches - Manual (Page 558)

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch Chapter 1 Information Center
1-7
Note:
Running the info-center synchronous command during debugging information
collection may result in a command prompt echoed after each item of debugging
information. To avoid unnecessary output, you are recommended to disable
synchronous terminal output in such cases.
1.2.2 Enabling Information Output to a Log Host
Table 1-5 lists the related configurations on the switch.
Table 1-5
Enable information output to a log host
Operation Command Description
Enter system view system-view —
Enable the
information center
info-center enable
Optional
By default, the information
center is enabled.
Enable information
output to a log host
info-center loghost
host
-ip-addr [ channel
{ channel-number |
channel
-name } | facility
local
-number | language
{ chinese | english } ]*
Required
By default, the switch does
not output information to the
log host.
After you configure the switch
to output information to the log
host, the switch uses
information channel 2 by
default.
Be sure to set the correct IP
address. A loopback IP
address will cause an error
message prompting that this
address is invalid.
Configure the
source interface
through which log
information is sent
to the log host
info-center loghost source
interface-type
interface-number
Optional
Define an
information source
info
-center source
{ modu-name | default }
channel
{ channel-number |
channel
-name } [ { log | trap
| debug } { level severity |
state
state } ]*
Required