H3C Technologies H3C S3100 Series Switches - Manual (Page 125)

Operation Manual – Port Basic Configuration
H3C S3100-52P Ethernet Switch Chapter 1 Port Basic Configuration
1-3
Caution:
You are recommended to set the default VLAN ID of the local hybrid or trunk ports to
the same value as that of the hybrid or trunk ports on the peer switch. Otherwise,
packet forwarding may fail on the ports.
1.1.4 Adding an Ethernet Port to Specified VLANs
You can add the specified Ethernet port to a specified VLAN. After that, the Ethernet
port can forward the packets of the specified VLAN, so that the VLAN on this switch can
intercommunicate with the same VLAN on the peer switch.
An access port can only be added to one VLAN, while hybrid and trunk ports can be
added to multiple VLANs.
Note:
The access ports or hybrid ports must be added to an existing VLAN.
1.2 Ethernet Port Configuration
1.2.1 Initially Configuring a Port
Table 1-3
Initially configure a port
Operation Command Remarks
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable the Ethernet
port
undo shutdown
Optional
By default, the port is
enabled.
Use the shutdown
command to disable the port.
Set the description of
the Ethernet port
description
text
Optional
By default, no description is
defined for the port.