H3C Technologies H3C S3100 Series Switches - Manual (Page 330)

Operation Manual – AAA – RADIUS – HWTACACS
H3C S3100-52P Ethernet Switch
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
1-31
immediately restores the communication with the primary server instead of
communicating with the secondary server, and at the same time restores the status of
the primary server to active while keeping the status of the secondary server
unchanged.
To control the interval at which users are charged in real time, you can set the real-time
accounting interval. After the setting, the switch periodically sends online users'
accounting information to RADIUS server at the set interval.
Table 1-21
Set the timers of RADIUS servers
Operation Command Description
Enter system view
system-view
—
Create a RADIUS
scheme and enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS
scheme named "system"
has already been created
in the system.
Set the response timeout
time of RADIUS servers
timer response-timeout
seconds
Optional
By default, the response
timeout time of RADIUS
servers is three seconds.
Set the time that the
switch waits before it try to
re-communicate with
primary server and
restore the status of the
primary server to active
timer quiet
minutes
Optional
By default, the switch
waits five minutes before
it restores the status of
the primary server to
active.
Set the real-time
accounting interval
timer
realtime-accounting
minutes
Optional
By default, the real-time
accounting interval is 12
minutes.
1.4.11 Enabling the Sending of Trap Message When a RADIUS Server is
Down
Table 1-22
Enable the sending of trap message when a RADIUS server is down
Operation Command Description
Enter system view
system-view
—
Enable the sending
of trap message
when a RADIUS
server is down
radius trap
{ authentication-server-do
wn
|
accounting-server-down
}
Optional
By default, the switch does
not send trap message when
a RADIUS server is down.