H3C Technologies H3C S3100 Series Switches - Manual (Page 272)

Operation Manual – Routing Protocol
H3C S3100-52P Ethernet Switch Chapter 2 Static Route Configuration
2-5
2.5 Troubleshooting a Static Route
Symptom: The switch is not configured with a dynamic routing protocol. Both the
physical status and the link layer protocol status of an interface are UP, but IP packets
cannot be normally forwarded on the interface.
Solution: Perform the following procedure.
Use the display ip routing-table protocol static command to view whether the
corresponding static route is correctly configured.
Use the display ip routing-table command to view whether the static route is valid.