H3C Technologies H3C S3100 Series Switches - Manual (Page 170)

Operation Manual – MAC Address Table
H3C S3100-52P Ethernet Switch
Chapter 1 MAC Address Table
Management
1-4
z
Configuring the maximum number of MAC addresses a port can learn
1.2.1 Configuring a MAC Address Entry
You can add, modify, or remove one MAC address entry, remove all MAC address
entries (unicast MAC addresses only) concerning a specific port, or remove specific
type of MAC address entries (dynamic or static MAC address entries).
You can add a MAC address entry in either system view or Ethernet port view.
I. Adding a MAC address entry in system view
Table 1-2
Add a MAC address entry in system view
Operation Command Description
Enter system view
system-view
—
Add a MAC address
entry
mac-address
{ static | dynamic |
blackhole
}
mac
-address interface
interface
-type interface-number vlan vlan-id
Required
Caution:
z
When you add a MAC address entry, the port specified by the interface argument
must belong to the VLAN specified by the vlan argument in the command.
Otherwise, the entry will not be added.
z
If the VLAN specified by the vlan argument is a dynamic VLAN, after a static MAC
address is added, it will become a static VLAN.
II. Adding a MAC address entry in Ethernet port view
Table 1-3
Add a MAC address entry in Ethernet port view
Operation Command Description
Enter system view system-view —
Enter Ethernet port
view
interface interface-type
interface-number
—
Add a MAC
address entry
mac-address
{ static | dynamic |
blackhole
} mac-address vlan vlan-id Required