H3C Technologies H3C S3100 Series Switches - Manual (Page 259)

Operation Manual – Multicast
H3C S3100-52P Ethernet Switch
Chapter 4 Multicast MAC Address Entry
Configuration
4-2
Operation Command Description
Create a multicast MAC
address entry.
mac
-address multicast
mac-address
vlan vlan-id
Required
The
mac-address
argument must be a
multicast MAC address
The vlan-id argument is
the ID of the VLAN to
which the port belongs.
Note:
z
If the multicast MAC address entry to be created already exists, the system gives
you a prompt.
z
If a multicast MAC address is added manually, the switch will not learn this multicast
MAC address again through IGMP Snooping. The undo mac-address multicast
command is used to delete the multicast MAC address entries created by the
mac
-address multicast command manually; however, it cannot be used to delete
the multicast MAC address entries learned by the switch.
z
If you want to add a port to a multicast MAC address entry created through the
mac
-address multicast command, you must delete this entry first, create this entry
again, and then add the specified port to the forwarding ports of this entry.
z
The system does not support adding multicast MAC addresses to IRF ports. If a port
is already an IRF port, the system will prompt that you cannot add multicast MAC
addresses to this port.
z
You cannot enable link aggregation on a port on which you have configured a
multicast MAC address; and you cannot configure a multicast MAC address on an
aggregation port.
4.3 Displaying and Maintaining Multicast MAC Address
After the configuration above, you can execute the display command in any view to
verify the configuration effect by checking the displayed information.
Table 4-3
Display and maintain multicast MAC address
Operation Command Description
Display the multicast
MAC address
entry/entries manually
configured
display mac-address
multicast
[ static
{ { { mac-address vlan
vlan-id | vlan vlan-id
}
[ count ] } | count } ]
You can use the display
command in any view.