H3C Technologies H3C S3100 Series Switches - Manual (Page 118)

Operation Manual – GVRP
H3C S3100-52P Ethernet Switch Chapter 1 GVRP Configuration
1-4
Field Description Value
Attribute Event
The event described by the
attribute
0: LeaveAll Event
1: JoinEmpty
2: JoinIn
3: LeaveEmpty
4: LeaveIn
5: Empty
Attribute Value The value of the attribute
The attribute value of
GVRP is the VID.
End Mark End mark of the GVRP PDU. —
1.1.3 Protocol Specifications
GVRP is defined in IEEE 802.1Q standard.
1.2 GVRP Configuration
The GVRP configuration tasks include configuring the timers, enabling GVRP, and
configuring the GVRP port registration mode.
1.2.1 Configuration Prerequisite
The port on which GVRP will be enabled must be set to a trunk port.
1.2.2 Configuration Procedure
Table 1-2
Configuration procedure
Operation Command Description
Enter system view
system-view
—
Configure the LeaveAll
timer
garp timer leaveall
timer-value
Optional
By default, the LeaveAll
timer is set to 1,000
centiseconds.
Enter Ethernet port
view
interface interface-type
interface-number
—
Configure the Hold,
Join, and Leave timers
garp timer
{ hold | join |
leave
} timer-value
Optional
By default, the Hold, Join,
and Leave timers are set to
10, 20, and 60
centiseconds respectively.
Exit and return to
system view
quit
—