H3C Technologies H3C S3100 Series Switches - Manual (Page 291)

Operation Manual – 802.1x
H3C S3100-52P Ethernet Switch Chapter 1 802.1x Configuration
1-18
Note:
As for the dot1x version-user command, if you execute it in system view without
specifying the interface-list argument, the command applies to all ports. You can also
execute this command in port view. In this case, this command applies to the current
port only and the interface-list argument is not needed.
1.5.4 Enabling DHCP-triggered Authentication
After performing the following configuration, 802.1X allows running DHCP on access
users, and users are authenticated when they apply for dynamic IP addresses through
DHCP.
Table 1-5
Enable DHCP-triggered authentication
Operation Command Description
Enter system view system-view —
Enable
DHCP-triggered
authentication
dot1x dhcp-launch
Optional
By default, DHCP-triggered
authentication is disabled.
1.5.5 Configuring Guest VLAN
Table 1-6
Configure Guest VLAN
Operation Command Description
Enter system view system-view —
Configure port
access method
dot1x port-method
portbased
Required
The default port access
method is
MAC-address-based. That is,
the macbased keyword is
used by default.
Enable the Guest
VLAN function
dot1x guest-vlan
vlan-id
[ interface interface-list ]
Required
By default, the Guest VLAN
function is disabled.