H3C Technologies H3C S3100 Series Switches - Manual (Page 564)

Operation Manual – Information Center
H3C S3100-52P Ethernet Switch Chapter 1 Information Center
1-13
Operation Command Description
Set the format of
time stamp
info-center timestamp
{ log | trap
| debugging } { boot | date |
none
}
Optional
This is to set the time
stamp format for
log/debugging/trap
information output.
This determines how
the time stamp is
presented to users.
Note:
To view debugging information of specific modules, you need to set the information
type as debug in the info-center source command, and enable debugging on
corresponding modules with the debugging command as well.
1.2.7 Enabling Information Output to the SNMP
Table 1-12 lists the related configurations on the switch.
Table 1-12
Enable information output to the SNMP
Operation Command Description
Enter system view system-view —
Enable the
information center
info-center enable
Optional
By default, the information
center is enabled.
Enable information
output to the
SNMP
info-center snmp channel
{ channel-number |
channel
-name }
Required
By default, the switch outputs
trap information to SNMP
through channel 5.
Define an
information source
info
-center source
{ modu-name | default }
channel
{ channel-number |
channel
-name } [ { log | trap
| debug } { level severity |
state
state } ]*
Required
Set the format of
time stamp
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Optional
This is to set the time stamp
format for log/debugging/trap
information output.
This determines how the time
stamp is presented to users.