2 remote loading using tftp, 2 remote loading using tftp -17 – H3C Technologies H3C S3100 Series Switches User Manual
Page 589
Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
Chapter 1 BootROM and Host Software
Loading
1-17
This will update Bootrom on unit 1. Continue? [Y/N] y
Upgrading Bootrom, please wait...
Upgrade Bootrom succeeded!
When rebooting the switch, use the file S3100-52P.btm as BootROM to finish BootROM
loading.
2) Loading host software
Loading the host software is the same as loading the BootROM program, except for
that the file to be downloaded is the host software file, and that you need to use the
boot boot-loader
command to select the host software at reboot of the switch.
Note:
z
The steps listed above are performed in the Windows operating system, if you use
other FTP client software, refer to the corresponding user’s guide before operation.
z
Only the configurations steps concerning loading are illustrated here, for detailed
description on the corresponding configuration commands, refer to the chapter
“FTP and TFTP”.
1.3.2 Remote Loading Using TFTP
The remote loading using TFTP is similar to that using FTP. The only difference is that
TFTP is used instead off FTP to load software to the switch, and the switch can only act
as a TFTP client.