H3C Technologies H3C S3100 Series Switches - Manual (Page 120)

Operation Manual – GVRP
H3C S3100-52P Ethernet Switch Chapter 1 GVRP Configuration
1-6
Timer Lower threshold Upper threshold
LeaveAll
This lower threshold is greater
than the timeout time of the
Leave timer. You can change
threshold by changing the
timeout time of the Leave timer.
32,765 centiseconds
1.3 Displaying and Debugging GVRP
After the above configuration, you can use the display command in any view to display
the configuration information and operating status of GVRP/GARP, and thus verify your
configuration. You can use the reset command in user view to clear GARP statistics.
Table 1-4
Display and debug GVRP
Operation Command Description
Display GARP statistics
display
garp statistics
[ interface interface-list ]
Display the settings of the
GARP timers
display garp timer
[ interface interface-list ]
Display GVRP statistics
display gvrp statistics
[ interface interface-list ]
Display the global GVRP
status
display gvrp status
The display command
can be executed in any
view.
Clear GARP statistics
reset garp statistics
[ interface interface-list ]
The reset command can
be executed in user
view.
1.4 GVRP Configuration Example
1.4.1 Network requirements
You need to enable GVRP on the switches to enable dynamic VLAN information
registration and update between the switches.
1.4.2 Network diagram
Switch A Switch B
E1/0/1 E1/
Switch A Switch B Switch A Switch B
0/2
Switch A Switch B
Figure 1-2
Network diagram for GVRP configuration