H3C Technologies H3C S3100 Series Switches - Manual (Page 197)

Operation Manual – MSTP
H3C S3100-52P Ethernet Switch
Chapter 1 MSTP Configuration
1-22
Note:
You are recommended to configure the Ethernet ports connected directly to terminals
as edge ports and enable the BPDU protection function at the same time. This not only
enables these ports to turn to the forwarding state rapidly but also secures your
network.
III. Configuration example
# Configure Ethernet1/0/1 as an edge port.
1) Configure Ethernet1/0/1 as an edge port in system view.
system-view
[H3C] stp interface ethernet1/0/1 edged-port enable
2) Configure Ethernet1/0/1 as an edge port in Ethernet port view.
system-view
[H3C] interface ethernet1/0/1
[H3C-Ethernet1/0/1] stp edged-port enable
1.2.13 Specifying Whether the Link Connected to a Port Is Point-to-point
Link
A point-to-point link directly connects two switches. If the roles of the two ports at the
two ends of a point-to-point link meet certain criteria, the two ports can turn to the
forwarding state rapidly by exchanging synchronization packets, thus reducing the
forward delay.
You can determine whether or not the link connected to a port is a point-to-point link in
one of the following two ways.