H3C Technologies H3C S3100 Series Switches - Manual (Page 503)

Operation Manual – SSH Terminal Service
H3C S3100-52P Ethernet Switch Chapter 1 SSH Terminal Service
1-17
Figure 1-11
SSH client interface
2) Enter the username and password to create an SSH connection.
3) To log out, enter the quit command.
1.1.4 Configuring the Device as an SSH Client
The following table describes SSH Client configuration tasks.
Table 1-9
SSH Client configuration tasks
Operation Command Description
Enter system view system-view —
Enable the client to
run initial
authentication
ssh client first-time enable
Optional
By default, the client is
enabled to run initial
authentication.
If the client is disabled
from running initial
authentication, you must
assign a public key to the
server on the client.