H3C Technologies H3C S3100 Series Switches - Manual (Page 119)

Operation Manual – GVRP
H3C S3100-52P Ethernet Switch Chapter 1 GVRP Configuration
1-5
Operation Command Description
Enable GVRP globally gvrp
Required
By default, GVRP is
disabled globally.
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable GVRP on the
port
gvrp
Required
By default, GVRP is
disabled on the port.
After you enable GVRP on
a trunk port, you cannot
change the port to a
different type.
Configure GVRP port
registration mode
gvrp registration
{ fixed |
forbidden
| normal }
Optional
You can choose one of the
three modes.
By default, GVRP port
registration mode is normal.
The timeout ranges of the timers vary depending on the timeout values you set for other
timers. If you want to set the timeout time of a timer to a value out of the current range,
you can set the timeout time of the associated timer to another value to change the
timeout range of this timer.
The following table describes the relations between the timers:
Table 1-3
Relations between the timers
Timer Lower threshold Upper threshold
Hold 10 centiseconds
This upper threshold is less
than or equal to one-half of the
timeout time of the Join timer.
You can change the threshold
by changing the timeout time of
the Join timer.
Join
This lower threshold is greater
than or equal to twice the timeout
time of the Hold timer. You can
change the threshold by
changing the timeout time of the
Hold timer.
This upper threshold is less
than one-half of the timeout
time of the Leave timer. You
can change the threshold by
changing the timeout time of
the Leave timer.
Leave
This lower threshold is greater
than twice the timeout time of the
Join timer. You can change the
threshold by changing the
timeout time of the Join timer.
This upper threshold is less
than the timeout time of the
LeaveAll timer. You can
change the threshold by
changing the timeout time of
the LeaveAll timer.