H3C Technologies H3C S3100 Series Switches - Manual (Page 607)

Operation Manual – VLAN VPN
H3C S3100-52P Ethernet Switch Chapter 1 VLAN-VPN Configuration
1-3
Protocol type Value
IPX 0x8137
IS-IS 0x8000
LACP 0x8809
802.1x 0x888E
1.2 VLAN-VPN Configuration
1.2.1 Configuration Prerequisites
z
GARP VLAN registration protocol (GVRP), neighbor topology discovery protocol
(NTDP), spanning tree protocol (STP), 802.1x, and centralized MAC address
authentication function are disabled on the port.
z
The port is an access port.
Caution:
z
The VLAN-VPN function is unavailable to a port if any of the protocols among GVRP,
NTDP, STP, 802.1x, and centralized MAC address authentication function is
enabled on the port.
z
By default, STP and NTDP are enabled on a device. You can disable these two
protocols using the stp disable and undo ntdp enable commands.
1.2.2 Configuration Procedure
Table 1-2
Configure the VLAN-VPN function for a port
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Enable the VLAN-VPN
function on the port
vlan-vpn enable
Required
By default, the VLAN-VPN
function is disabled on a
port.