H3C Technologies H3C S3100 Series Switches - Manual (Page 289)

Operation Manual – 802.1x
H3C S3100-52P Ethernet Switch Chapter 1 802.1x Configuration
1-16
Note:
z
As for the dot1x max-user command, if you execute it in system view without
specifying the interface-list argument, the command applies to all ports. You can
also use this command in port view. In this case, this command applies to the
current port only and the interface-list argument is not needed.
z
As for the configuration of 802.1x timers, the default values are recommended.
1.5 Advanced 802.1x Configuration
Advanced 802.1x configurations, as listed below, are all optional.
z
Configuration concerning CAMS, including multiple network adapters detecting,
proxy detecting, and so on.
z
Client version checking configuration
z
DHCP –triggered authentication
z
Guest VLAN configuration
1.5.1 Prerequisites
Basic 802.1x configuration is performed.
1.5.2 Configuring Proxy Checking
This function needs the cooperation of 802.1x client program and CAMS server, as
listed below.
z
The 802.1x client needs to capable of detecting multiple network adapters, proxies,
and IE proxies.
z
The CAMS server is configured to disable the use of multiple network adapters,
proxies, or IE proxies.
By default, an 802.1x client program allows use of multiple network adapters, proxies,
and IE proxies. In this case, if the CAMS server is configured to disable use of multiple
network adapters, proxies, or IE proxies, it prompts the 802.1x client to disable use of
multiple network adapters, proxies, or IE proxies through messages after the supplicant
system passes the authentication.