H3C Technologies H3C S3100 Series Switches - Manual (Page 592)

Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
Chapter 2 Basic System Configuration
& Debugging
2-3
Perform the following configuration in user view.
Table 2-6
Set the summer time
Operation Command Description
Set the name and
time range of the
summer time
clock summer-time
zone-name { one-off |
repeating
} start-time start-date end-time
end-date offset-time
Optional
2.1.7 Setting the CLI Language Mode
Table 2-7
Set the CLI language mode
Operation Command Description
Set the CLI
language mode
language-mode
{ chinese | english }
Optional
By default, the command line interface
(CLI) language mode is English.
2.1.8 Returning from Current View to Lower Level View
Table 2-8
Return from current view to lower level view
Operation Command Description
Return from current view
to lower level view
quit
This operation will result in exiting the
system if current view is user view.
2.1.9 Returning from Current View to User View
Table 2-9
Return from current view to user view
Operation Command Description
Return from current
view to user view
return
The composite key has the same
effect with the return command.
2.2 Displaying the System Status
You can use the following display commands to check the status and configuration
information about the system. For information about protocols and ports, and the
associated display commands, refer to relevant sections.