H3C Technologies H3C S3100 Series Switches - Manual (Page 594)

Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
Chapter 2 Basic System Configuration
& Debugging
2-5
1 2 3
ON
Protocol debugging switches
ON OFF
ON OFF
1
3
1
Debugging information
1 2
3
Terminal display switches
1
3
ON
Protocol debugging switches
ON OFF
ON OFF
1
3
1
3
Terminal display switches
1
33
t
Debugging information
Figure 2-1
Debugging information outpu
You can use the following commands to operate the two kinds of switches.
Perform the following operations in user view.
Table 2-11
Enable debugging and terminal display
Operation Command Description
Enable system
debugging
debugging
module-name
[ debugging-option ]
By default, all debugging is
disabled in the system.
Because the output of
debugging information will
affect the efficiency of the
system, disable your
debugging after you finish it.
Enable terminal
display for
debugging
terminal debugging
By default, terminal display
for debugging is disabled.