H3C Technologies H3C S3100 Series Switches - Manual (Page 422)

Operation Manual – Mirroring
H3C S3100-52P Ethernet Switch Chapter 1 Mirroring Configuration
1-13
[H3C-vlan10] quit
[H3C] interface GigabitEthernet 1/1/1
[H3C-GigabitEthernet1/1/1] port link-type trunk
[H3C-GigabitEthernet1/1/1] port trunk permit vlan 10
[H3C-GigabitEthernet1/1/1] quit
[H3C] interface GigabitEthernet 1/1/2
[H3C-GigabitEthernet1/1/2] port link-type trunk
[H3C-GigabitEthernet1/1/2] port trunk permit vlan 10
# Configure Switch A.
system-view
[H3C] vlan 10
[H3C-vlan10] remote-probe vlan enable
[H3C-vlan10] quit
[H3C] interface GigabitEthernet 1/1/1
[H3C-GigabitEthernet1/1/1] port link-type trunk
[H3C-GigabitEthernet1/1/1] port trunk permit vlan 10
[H3C-GigabitEthernet1/1/1] quit
[H3C] mirroring-group 1 remote-destination
[H3C] mirroring-group 1 monitor-port GigabitEthernet 1/1/2
[H3C] mirroring-group 1 remote-probe vlan 10
[H3C] display mirroring-group remote-destination
mirroring-group 1:
type: remote-destination
status: active
monitor port: GigabitEthernet1/1/2
remote-probe vlan: 10
1.3 Displaying Mirroring Parameter Settings
After the above configuration, you can use the display command in any view to view
the mirroring running information, so as to verify the configurations you made.
Table 1-8
Display mirroring parameter settings
Operation Command Description
Display parameter settings
of a mirroring group
display mirroring-group
{ group-id
| all | local | remote-destination |
remote-source
}
The
command can
be executed
in any view.