H3C Technologies H3C S3100 Series Switches - Manual (Page 600)

Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch Chapter 4 Device Management
4-3
4.2.5 Updating the BootROM
You can use the BootROM application saved in the Flash memory of the switch to
update the running BootROM application. With this command, a remote user can
conveniently update the BootRom by uploading the BootROM to the switch through
FTP and running this command. The BootROM can be used when the switch reboots.
Perform the following configuration in user view:
Table 4-5
Update the BootROM
Operation Command Description
Update the
BootROM
boot bootrom
{
file
-url |
device-name
}
Optional
4.3 Displaying the Device Management Configuration
After the above configurations, you can execute the display command in any view to
display the operating status of the device management to verify the configuration
effects.
Table 4-6
Display the operating status of the device management
Operation Command Description
Display the APP to be adopted
at reboot
display boot-loader
[ unit
unit-id
]
Display the module type and
operating status of each board
display device
[ manuinfo
[ unit unit-id ] | unit unit-id ]
Display CPU usage of a switch display cpu [ unit unit-id ]
Display the operating status of
the fan
display fan
[ unit unit-id
[ fan-id ] ]
Display memory usage of a
switch
display memory
[ unit unit-id ]
Display the operating status of
the power supply
display power
[ unit unit-id
[ power-id ] ]
Display system diagnostic
information or save system
diagnostic information to a file
suffixed with diag in the Flash
memory
display
diagnostic-information
Display enabled debugging on a
specified switch
display debugging
{ unit
unit-id
} [ interface
interface-type interface-number
|
module-name
]
You can
execute the
display
command in
any view.