H3C Technologies H3C S3100 Series Switches - Manual (Page 101)

Operation Manual – VLAN
H3C S3100-52P Ethernet Switch Chapter 2 VLAN Configuration
2-3
Table 2-3
Display VLAN configuration
Operation Command Description
Display the VLAN
interface information
display
interface Vlan-interface
[ vlan-id ]
Display the VLAN
information
display
vlan [ vlan-id [ to vlan-id ]
| all | dynamic | static ]
You can execute the
display
command in
any view.
2.2 Configuring a Port-Based VLAN
2.2.1 Configuring a Port-Based VLAN
I. Configuration prerequisites
Create a VLAN before configuring a port-based VLAN.
II. Configuration procedure
Table 2-4
Configure a port-based VLAN
Operation Command Description
Enter system view system-view —
Enter VLAN view
vlan
vlan-id —
Add Ethernet ports
to the specific
VLAN
port interface-list
Required
By default, all the ports belong
to the default VLAN
Caution:
The commands above are effective for access ports only. If you want to add trunk ports
or hybrid ports to a VLAN, you can use the port trunk permit vlan command or the
port hybrid vlan
command in Ethernet port view. For the configuration procedure,
refer to the section "Port Basic Configuration – Operation" in H3C S3100-52P Ethernet
Switch Operation Manual
.
2.2.2 Protocol-Based VLAN Configuration Example
I. Network requirements
z
Create VLAN 2 and VLAN 3 and specify the description string of VLAN 2 as home;