H3C Technologies H3C S3100 Series Switches User Manual
Page 539
Operation Manual – FTP and TFTP
H3C S3100-52P Ethernet Switch
Chapter 1 FTP and TFTP Configuration
1-7
[H3C] ftp server enable
[H3C] local-user switch
[H3C-luser-switch] password simple hello
[H3C-luser-switch] service-type ftp
2) Run an FTP client application on the PC to connect to the FTP server. Upload the
application named switch.bin to the root directory of the Flash memory of the FTP
server, and download the configuration file named config.cfg from the FTP server.
The following takes the command line window tool provided by Windows as an
example:
# Enter the command line window and switch to the directory where the file switch.bin is
located. In this example it is in the root directory of C:\.
C:\>
# Access the Ethernet switch through FTP. Input the user name “switch” and password
“hello” to log in and enter FTP view.
C:\> ftp 1.1.1.1
Connected to 1.1.1.1.
220 FTP service ready.
User (1.1.1.1:(none)): switch
331 Password required for switch.
Password:
230 User logged in.
ftp>
# Upload the switch.bin file.
ftp> put switch.bin
200 Port command okay.
150 Opening ASCII mode data connection for switch.bin.
226 Transfer complete.
# Download the config.cfg file.
ftp> get config.cfg
200 Port command okay.
150 Opening ASCII mode data connection for config.cfg.
226 Transfer complete.
ftp: 3980 bytes received in 8.277 seconds 0.48Kbytes/sec.
This example uses the command line window tool provided by Windows. When you log
into the FTP server through another FTP client, refer to the corresponding instructions
for operation description.