H3C Technologies H3C S3100 Series Switches - Manual (Page 439)

Operation Manual – Cluster
H3C S3100-52P Ethernet Switch Chapter 1 Cluster
1-16
Table 1-18
Display and maintain cluster configuration
Operation Command Description
Display all NDP configuration
and running information
(including the interval to send
NDP packets, the holdtime, and
all neighbors discovered)
display ndp
Display NDP configuration and
running information on specified
ports (including the neighbors
discovered by NDP on the
ports)
display ndp interface
port-list
Display global NTDP
information
display ntdp
Display device information
collected by NTDP
display ntdp device-list
[ verbose ]
Display status and statistics
information about the cluster
display cluster
Display information about the
candidate devices of the cluster
display cluster
candidates
[ mac-address H-H-H |
verbose
]
Display information about the
member devices of the cluster
display cluster members
[
member-number
|
verbose
]
You can execute
the
display
command in any
view.
Clear NDP statistics on ports
reset ndp statistics
[ interface port-list ]
You can execute
the
reset
command in user
view.
1.6 Cluster Configuration Example
1.6.1 Basic Cluster Configuration Example
I. Network requirements
Three switches compose a cluster, where:
z
An S3100-52P switch serves as the management device.
z
The rest are member devices.
Serving as the management device, the S3100-52P switch manages the two member
devices. The configuration for the cluster is as follows:
z
The two member devices connect to the management device through
Ethernet1/0/2 and Ethernet1/0/3.
z
The management device connects to the Internet through Ethernet1/0/1.