H3C Technologies H3C S3100 Series Switches - Manual (Page 448)

Operation Manual – SNMP and RMON
H3C S3100-52P Ethernet Switch Chapter 1 SNMP Configuration
1-3
Table 1-1
Common MIBs
MIB attribute MIB content Related RFC
MIB II based on TCP/IP network device RFC1213
RFC1493
BRIDGE MIB
RFC2675
RIP MIB RFC1724
RMON MIB RFC2819
Ethernet MIB RFC2665
OSPF MIB RFC1253
Public MIB
IF MIB RFC1573
Private MIB
DHCP MIB
QACL MIB
ADBM MIB
RSTP MIB
VLAN MIB
Device management
Interface management
—
1.2 Configuring Basic SNMP Functions
SNMPv3 configuration is quite different from that of SNMPv1 and SNMPv2C. Therefore,
the configuration of basic SNMP functions is described by SNMP versions, as listed in
Table 1-2 and Table 1-3.
Table 1-2
Configure basic SNMP functions (SNMPv1 and SNMPv2C)
Operation Command Description
Enter system view
system-view
—
Enable SNMP agent
snmp-agent
Optional
By default, SNMP
agent is disabled.
You can enable
SNMP agent by
executing this
command or any of
the commands used
to configure SNMP
agent.