H3C Technologies H3C S3100 Series Switches - Manual (Page 195)

Operation Manual – MSTP
H3C S3100-52P Ethernet Switch
Chapter 1 MSTP Configuration
1-20
I. Configure the maximum transmitting speed for specified ports in system
view
Table 1-13 Configure the maximum transmitting speed for specified ports in system
view
Operation Command Description
Enter system view system-view —
Configure the
maximum
transmitting speed
for specified ports
stp interface
interface-list
transmit-limit
packetnum
Required
The maximum transmitting
speed of all Ethernet ports on a
switch defaults to 10.
II. Configure the maximum transmitting speed in Ethernet port view
Table 1-14 Configure the maximum transmitting speed in Ethernet port view
Operation Command Description
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the maximum
transmitting speed stp transmit-limit
packetnum
Required
The
maximum
transmitting speed of all
Ethernet ports on a switch
defaults to 10.
As the maximum transmitting speed parameter determines the number of the
configuration BPDUs transmitted in each hello time, set it to a proper value to prevent
MSTP from occupying too many network resources. The default value is
recommended.
III. Configuration example
# Set the maximum transmitting speed of Ethernet1/0/1 to 15.
1) Configure the maximum transmitting speed in system view.
system-view
[H3C] stp interface ethernet1/0/1 transmit-limit 15
2) Configure the maximum transmitting speed in Ethernet port view.
system-view
[H3C] interface ethernet1/0/1
[H3C-Ethernet1/0/1] stp transmit-limit 15