H3C Technologies H3C S3100 Series Switches - Manual (Page 538)

Operation Manual – FTP and TFTP
H3C S3100-52P Ethernet Switch Chapter 1 FTP and TFTP Configuration
1-6
Table 1-6
Display FTP server information
Operation Command Description
Display the information about FTP
server configurations on a switch
display ftp-server
Display the source IP address set
for an FTP server
display ftp-server
source-ip
Display the login FTP client on an
FTP server
display ftp-user
These commands can
be executed in any
view.
1.1.3 Configuration Example: A Switch Operating as an FTP Server
I. Network requirements
A switch operates as an FTP server and a remote PC as an FTP client.
z
Create a user account on the FTP server with the user name “switch” and
password “hello”.
z
Configure the IP address 1.1.1.1/16 for a VLAN interface on the switch, and
2.2.2.2/16 for the PC. Ensure the route between the two is reachable.
The switch application named switch.bin is stored on the PC. Upload it to the FTP
server through FTP to upgrade the application of the switch, and download the switch
configuration file named config.cfg from the switch to backup the configuration file.
II. Network diagram
Switch PC
Network Network
Switch PC
Network Network
Figure 1-2
Network diagram for FTP configurations
III. Configuration procedure
1) Configure the switch
# Log into the switch. (You can log into a switch through the Console port or by
Telneting to the switch. See the “Login” module for detailed information.)
# Start the FTP service on the switch and set the user name and the corresponding
password.