H3C Technologies H3C S3100 Series Switches - Manual (Page 290)

Operation Manual – 802.1x
H3C S3100-52P Ethernet Switch Chapter 1 802.1x Configuration
1-17
Table 1-3
Configure proxy checking
Operation Command Description
Enter system view
system-view
—
Enable proxy checking
function globally
dot1x
supp-proxy-check
{ logoff | trap }
Required
By default, the 802.1x
proxy checking function is
globally disabled.
In system view:
dot1x
supp-proxy-check
{ logoff | trap }
[ interface interface-list ] Enable proxy checking
for a port/specified ports
In port view:
dot1x
supp-proxy-check
{ logoff | trap }
Required
By default, the 802.1x
proxy checking is disabled
on a port.
Note:
z
The proxy checking function needs the cooperation of H3C's 802.1x client program.
z
The configuration listed in Table 1-3 takes effect only when it is performed on CAMS
as well as on the switch. In addition, the client version checking function needs to be
enabled on the switch too (by using the dot1x version-check command).
1.5.3 Configuring Client Version Checking
Table 1-4
Configure client version checking
Operation Command Description
Enter system view system-view —
Enable 802.1x
client version
checking
dot1x version-check
[ interface interface-list ]
Required
By default, 802.1x client
version checking is disabled
on a port.
Set the maximum
number of retires
to send version
checking request
packets
dot1x retry-version-max
max-retry-version-value
Optional
By default, the maximum
number of retires to send
version checking request
packets is 3.
Set the client
version checking
period timer
dot1x
timer ver-period
ver-period-value
Optional
By default, the timer is set to
30 seconds.