H3C Technologies H3C S3100 Series Switches - Manual (Page 37)

Operation Manual – Login
H3C S3100-52P Ethernet Switch Chapter 2 Logging in through the Console Port
2-3
Figure 2-4
Set port parameters
3) Turn on the switch. You will be prompted to press the Enter key if the switch
successfully completes POST (power-on self test). The prompt (such as )
appears after you press the Enter key.
4) You can then configure the switch or check the information about the switch by
executing the corresponding commands. You can also acquire help by typing the ?
character. The commands available on a switch are described in the command
manuals.
2.3 Console Port Login Configuration
2.3.1 Common Configuration
Table 2-2 lists the common configuration of Console port login.
Table 2-2
Common configuration of Console port login
Configuration Remarks
Baud rate
Optional
The default baud rate is 9,600 bps.
Check mode
Optional
By default, the check mode of the Console
port is set to “none”, which means no check
bit.
Stop bits
Optional
The default stop bits of a Console port is 1.
Console port
configuration
Data bits
Optional
The default data bits of a Console port is 8.