H3C Technologies H3C S3100 Series Switches User Manual
Page 149
Operation Manual – Link Aggregation
H3C S3100-52P Ethernet Switch
Chapter 1 Link Aggregation Configuration
1-13
[H3C-Ethernet1/0/3] port link-aggregation group 1
2) Adopting
static
LACP aggregation mode
# Create static aggregation group 1.
[H3C] link-aggregation group 1 mode static
# Add Ethernet1/0/1 through Ethernet1/0/3 to aggregation group 1.
[H3C] interface Ethernet1/0/1
[H3C-Ethernet1/0/1] port link-aggregation group 1
[H3C-Ethernet1/0/1] interface Ethernet1/0/2
[H3C-Ethernet1/0/2] port link-aggregation group 1
[H3C-Ethernet1/0/2] interface Ethernet1/0/3
[H3C-Ethernet1/0/3] port link-aggregation group 1
3) Adopting
dynamic
LACP aggregation mode
# Enable LACP on Ethernet1/0/1 through Ethernet1/0/3.
[H3C] interface Ethernet1/0/1
[H3C-Ethernet1/0/1] lacp enable
[H3C-Ethernet1/0/1] interface Ethernet1/0/2
[H3C-Ethernet1/0/2] lacp enable
[H3C-Ethernet1/0/2] interface Ethernet1/0/3
[H3C-Ethernet1/0/3] lacp enable
Note that, the three LACP-enabled ports can be aggregated into a dynamic
aggregation group to implement load sharing only when they have the same basic
configuration (such as rate and duplex mode and so on).