Carrier Access Network Device Axxius 800 - Manual (Page 86)

4-14 Axxius 800 - Release 2.2
Configuration
Setup of DS0 Management Channel
Setup of DS0 Management Channel
The DS0 Management Channel provides an alternative to the FDL link for
management information where FDL is unavailable. The Access Navigator and the
remote Axxius 800 will use IP packets to communicate management and control
information over the DS0 Management channel. A DS0 Channel will be used in the
remote Axxius 800 to send and receive the management IP packets.
The Navigator sends and receives the IP packets over its Ethernet connection while the
remote Axxius sends and receives the IP packets over a DS0 channel. A channelized
router takes the IP messages from the Ethernet to send them over DS0 channels (WAN)
and vice versa. The DS0s coming out of the router are on a single T1. It connects to the
Navigator, where the DS0s are cross-connected to the remote Axxius.
The following procedure will walk you through the basic setup of a DS0 Management
Channel.
Axxius
with Router
192.168.201.101
Axxius
(Axxius1)
192.168.202.1
Axxius
(Axxius2)
192.168.202.2
Access
Navigator
192.168.201.100
One Management
T1 DS0 for each
Remote Axxius 800
IP packets carry Remote
Mgmt messages
PC
192.168.201.102
T1 DS0 carrying
IP Packets
EOD messages
carry ISDN
Voice
Switch