Carrier Access Network Device Axxius 800 - Manual (Page 225)

Axxius 800 - Release 2.2 5-125
CLI Commands
set
set (router) ppp auth
Use the set (router) ppp auth command to configure the PPP (Point-to-Point Protocol)
authentication on the specified Router card.
set (router) ppp auth byremote protocol
Syntax: set {rtr_card-addr} ppp auth byremote protocol
{chap|none|pap}
Example: set 5 ppp auth byremote protocol none
The example will set the Router in slot 5 to not allow PPP authentication of this
Axxius by the remote PPP device.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{chap|none|pap}
set (router) ppp auth byremote secret
Syntax: set {tsr_card-addr} ppp auth byremote secret
{"password"}
Example: set 5 ppp auth byremote secret "public"
The example will set the PPP authentication secret/password for the TSR in slot
5 to "public"
Note: A set (router) ppp auth by remote protocol command must be
completed before this command can be implemented.
{tsr_card-addr}
The slot number (1-8) that contains the TSR card.
{"password"}
A password with a maximum of 15 characters, enclosed in quotes.
chap Set to the CHAP protocol.
none The remote PPP device cannot authenticate this Axxius (default).
pap Set to the PAP protocol.