Carrier Access Network Device Axxius 800 - Manual (Page 161)

Axxius 800 - Release 2.2 5-61
CLI Commands
load
load xmodem
Use the load xmodem command to download software via Xmodem. This command is only
available with an RS-232 connection. If you are using Telnet, see load tftp command.
Syntax: load {ctrlr-id} xmodem
Example: load a2 xmodem
The example initiates an modem transfer to the Controller card in slot A2.
Do you really want to do this?
Enter Y at the prompt to continue, or N to cancel the download.
Y - the system will prompt you to select the appropriate local file. With the file selected, the
system will complete the download, reboot, and run the installation for flash upgrade. Screen
example following.
**** System Boot ****
Copyright 1999,2000 Carrier Access Corporation.
XMODEM transfer started
Validating image(fast)..........................SUCCEEDED!
Erasing FLASH:..........................Finished Erasing FLASH!
Erasing FLASH:..........................Finished Erasing FLASH!
Programming Flash..........................SUCCEEDED!
In 5 seconds the system will boot from Flash
Press any key to stop boot . 5 . 4 . 3 . 2 . 1 . 0
Looking for valid application image in Flash...
Executing application image from Flash
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
Axxius startup
{ctrlr_id}
ctrlr_id Controller identifier to download the software to.
A1, A2 All, Active or Standby