Carrier Access Network Device Axxius 800 - Manual (Page 136)

5-36 Axxius 800 - Release 2.2
CLI Commands
clear
clear (ds3)
Use the clear (ds3) command to clear specified DS3 performance data.
Note this command applies only when using a DS3 Controller card.
Syntax: clear {ds3-addr} performance {setting}
Example: clear a:1 performance all
Clears all performance data on DS3 1 (port 1) on the Controller card.
{ds3-addr}
DS3 address in the form {slot:port}.
{setting}
slot A for the controller card, or 1-8 for service cards.
port Port number, range or all.
all Clear all performance data
ccv Clear ccv (C-bit code violations) performance data.
ccvfe Clear far end ccv (C-bit code violations) performance data.
ces Clear ces (C-bit errored seconds) performance data.
cesfe Clear far end ces (C-bit errored seconds) performance data.
cses Clear cses (C-bit severely errored seconds) performance data.
csesfe Clear far end cses (C-bit severely errored seconds) performance data.
lcv Clear lcv (line code violations) performance data.
les Clear les (line errored seconds) performance data.
pcv Clear pcv (path code violations) performance data.
pes Clear pes (P-bit errored seconds) performance data.
pses Clear pses (P-bit severely errored seconds) performance data.
sefs Clear sefs (severely errored frame seconds) performance data.
uas Clear uas (unavailable seconds) performance data.
uasfe Clear far end uas (unavailable seconds) performance data.