Set (ocudp) baud, Set (ocudp) baud -97 – Carrier Access Network Device Axxius 800 User Manual
Page 197

Axxius 800 - Release 2.2
5-97
CLI Commands
set
set (ocudp) baud
Use the set (ocudp) baud command to configure the Baud Rate for OCU-DP ports.
Syntax:
set {ocudp-addr} baud {rate}[sw56|sw56cp]
Example:
set 3:2 baud 2400
Set the baud rate on port 2 to 2400, on the OCU-DP card in slot 3.
{ocudp-addr}
The {slot:port} address of the OCU-DP card you want to apply the changes to.
{rate}
slot
Slot number (1-8) where the OCU-DP is located
port
Port number or range.
2400
Set OCU-DP baud rate to 2400
4800
Set OCU-DP baud rate to 4800
9600
Set OCU-DP baud rate to 9600
19200
Set OCU-DP baud rate to 19200
38400
Set OCU-DP baud rate to 38400
56000*
Set OCU-DP baud rate to 56000. This is the default.
sw56
Set to switched 56 service
sw56cp
Set to switched 56 service with call progress capability. Sends
special call progress CMI codes to DSU.
64000
Set OCU-DP baud rate to 64000