Carrier Access Network Device Axxius 800 - Manual (Page 199)

Axxius 800 - Release 2.2 5-99
CLI Commands
set
set (ocudp) loopdetect
Use the set (ocudp) loopdetect to configure the OCU non-latching/latching loopback code
detection.
Syntax: set {ocudp-addr} loopdetect {csu|dsu|ocu} {llb|nllb}
{disable|enable}
Example: set 3:2 loopdetect csu llb enable
{ocudp-addr}
The {slot:port} address of the OCU-DP card to apply the changes to.
{csu|dsu|ocu}
{llb|nllb}
{disable|enable}
slot Slot number (1-8) where the OCU-DP is located
port Port number or range.
csu Set CSU manual loop codes detection
dsu Set DSU manual loop codes detection
ocu Set OCU manual loop codes detection
llb Set up latching loopback detection
nllb Set up non-latching loopback detection
disable Disable loop detection
enable Enable loop detection