Carrier Access Network Device Axxius 800 - Manual (Page 184)

5-84 Axxius 800 - Release 2.2
CLI Commands
set
frame Set the DS3 frame PMDL ID string
Command syntax: set {ds3-addr} frame {"string"}
{"string"} = transmission vendor’s identification, up to 10 characters,
enclosed in quotes.
framing Set the DS3 framing type
cbit To C-bit framing
m23 To M23 framing
gennum Set the DS3 generator number PMDL string
Command syntax: set {ds3-addr} gennum {"string"}
{"string"} = transmission vendor’s identification, up to 38 characters,
enclosed in quotes.
id Set the DS3 ID.
Command syntax: set {ds3-addr} id {"id-name"}
{"id-name"} = up to 30 characters, enclosed in quotes.
line Set a line loopback on the DS3.
loopdown Disable loopback on the DS3
loopup Enable loopback on the DS3
location id Set the DS3 location PMDL ID string
Command syntax: set {ds3-addr} location id {"string"}
{"string"} = transmission vendor’s identification, up to 11 characters,
enclosed in quotes.
loopdetect Set detection of loopback requests
off Disable detection of loopback requests
on Enable detection of loopback requests
payload Set the payload loopback on the DS3
loopdown Disable the payload loopback
loopup Enable the payload loopback
portnum Set the DS3 port number PMDL string
Command syntax: set {ds3-addr} portnum {"string"}
{"string"} = transmission vendor’s identification, up to 38 characters,
enclosed in quotes.
protect Set port protection on the DS3
off Disable port protection of loopback requests
on Enable port protection of loopback requests