Carrier Access Network Device Axxius 800 - Manual (Page 119)

Axxius 800 - Release 2.2 5-19
CLI Commands
add
add (router-lan) static
Use the add (router-lan) static commands to add static elements on the specified LAN
interface.
add (router-lan) static ip address
Use the add (router-lan) static ip address command to add a static IP address to the table
of learned addresses on the specified LAN interface. This command is typically used in
bridging.
Syntax: add {tsr_lan-addr} static ip address {"addr-name"}
{ip-addr}
Example: add 3:1 static ip address "JDoe" 195.168.201.140
{rtr_lan-addr}
The Router address is in the form {slot:port} or {slot "profile-name"}.
{"addr-name"}
A symbolic name for this static ip address. This name must be enclosed in quotes, with a
maximum of 8 characters.
{ip-addr}
The IP address of the learned address table for the LAN, in the form of xxx.xxx.xxx.xxx,
where xxx is between 0-255.
slot Slot number (1-8) that contains the Router card.
port Port number of the Router.
"profile-name" The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.