Set (router) password, Set (router) password -114 – Carrier Access Network Device Axxius 800 User Manual
Page 214

5-114
Axxius 800 - Release 2.2
CLI Commands
set
set (router) ntp timezone
Use the set (router) ntp timezone command to specify the timezone offset relative to GMT
for this TSR.
Note: not operational in this release.
Syntax:
set {rtr_card-addr} ntp timezone {hour-offset}
[minute-offset]
Example:
set 1 ntp timezone -5
The example will specify the gateway time to be 5 hours from GMT (Greenwich
Mean Time), which equates to Eastern Standard time, for the Router in slot 1.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{hour-offset}
Used to calculate gateway time from GMT. The hour-offset range is -12 to 12.
[minute-offset]
Used to calculate gateway time from GMT. The minute-offset range is 0 to 60.
set (router) password
Use the set (router) password command to manage password access on the specified Router
card.
Syntax:
set {rtr_card-addr} password {setting} {"password"}
Example:
set 5 password view "Fred"
The example will set the password to the view level to "Fred" on the Router card
in slot 5.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{setting}
{"password"}
A password with a maximum of 15 characters. Password must be enclosed in quotes, and
is case-sensitive.
admin
Set Administration level password on the Router.
config
Set Configuration level password on the Router.
security
Set Security level password on the Router.
view
Set View level password on the Router.