Carrier Access Network Device Axxius 800 - Manual (Page 235)

Axxius 800 - Release 2.2 5-135
CLI Commands
set
set (router) stp bridge maxage
Use the set (router) stp bridge maxage command to configure Spanning Tree maximum
age value for the bridge. The bridge max age value specifies the maximum age of received
protocol information before it is discarded.
Syntax: set {rtr_card-addr} stp maxage {value}
Example: set 3 stp bridge maxage 15
The example will set the Spanning Tree bridge max age to 15 seconds, on the
Router in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{value}
The value can range from 6 to 40 seconds, with a default of 20.
set (router) stp bridge priority
Use the set (router) stp bridge priority command to configure Spanning Tree priority
value for the bridge.
Syntax: set {rtr_card-addr} stp priority {value}
Example: set 3 stp bridge priority 32768
The example will set the Spanning Tree bridge priority to 32768, on the Router
in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{value}
The value can range from 0 to 65535, with a default of 32768.