Carrier Access Network Device Axxius 800 - Manual (Page 461)

Axxius 800 - Release 2.2 15-9
Terminal Server Router Card
Card Configuration
l add (router-lan) filter
Add an address filter to the table of Layer 2 filter applied specified LAN
interface.
l add (router-lan) secondary ip address
Add a secondary IP address and subnet to the LAN interface.
l add (router-lan) static
Add a static element on the specified LAN.
l add (router-wan) firewall
Add a firewall rule to a WAN.
l add (router-wan) gre network
Add a "by network" GRE tunnel to a WAN.
l add (router-wan) static
Add a static IP address to the table of learned addresses on the WAN
interface. This command is typically used in bridging.
l clear (router) ip address table
Flush the learned entries from the IP address table for the specific interface
from the specified TSR card.
l clear (router) mac address table
Flush the learned entries from the MAC address table for the specific
interface from the specified TSR card.
l connect (router-trunk) (t1)
Creates two-way connections between the router port trunk connections and
any DS0 channels of the service card or controller.
l delete (router) dhcp server option
Remove optional DHCP server attributes.
l delete (router) dns proxy
Remove a remote DNS server address from the specified TSR card.
l delete (router) remote
Delete a remote WAN profile from the WAN profile table.
l delete (router) snmp community
Delete an SNMP community entry.
l delete (router) snmp trap
Delete a trap destination from the TSR card.