Carrier Access Network Device Axxius 800 - Manual (Page 497)

Axxius 800 - Release 2.2 18-9
Maintenance
Backup Axxius 800 Configuration
Backup Axxius 800 Configuration
A text file from the current configuration can be generated to reload the in the event the
configuration has been lost due to card or software problems. The download of the file,
generated by the
print config command, can be done by direct connect to the
RS-232 port or via Telnet. The upload of the file from the PC back to the Axxius 800
can only be done via direct RS-232 connection. This is because the Axxius 800 will be
at factory default and an IP address is not assigned to the Axxius 800.
Save Controller Configuration
The following example is shown with a Hyperterm session, with Telnet selections in
parenthesis, other programs may be used and the process is similar, however the menu
selections may be different.
1. Start a HyperTerm session to an Axxius 800.
2. Type the CLI command print config and do not hit [E NTER ] .
3. Type select Transfer/Capture Text from the drop-down menu.
(Telnet - Terminal/Start Logging)
4. Name the file, select OK.
5. Return to the CLI command print config and hit [E NTER ] .
This process will exclude the print config command itself, from the
configuration file you are creating.
6. (Telnet - Select Terminal/Stop Logging).
7. Save configuration file as a .txt file, if necessary (Telnet will create a .log file,
which will need to be "saved as" a .txt file).