beautypg.com

Carrier Access Network Device Axxius 800 User Manual

Page 236

background image

5-136

Axxius 800 - Release 2.2

CLI Commands

set

set (router) stp enable/disable

Use the set (router) stp enable/disable command to enable and disable Spanning Tree
Protocol on the Router.

Syntax:

set {rtr_card-addr} stp {disable|enable}

Example:

set 3 stp enable

The example will enable Spanning Tree on the Router in slot 3.

{rtr_card-addr}

The slot number (1-8) that contains the Router card.

Note: Enter {slot} only. If {slot:port} is entered the command will be directed to the
Router LAN and not the Router Card.

{disable|enable}

disable

Disable Spanning Tree protocol

enable

Enable Spanning Tree protocol