Carrier Access Network Device Axxius 800 - Manual (Page 145)

Axxius 800 - Release 2.2 5-45
CLI Commands
delete
delete (router) remote
Use the delete (router) remote command to delete a remote WAN profile from the WAN
profile table on the specified Router card.
Syntax: delete {rtr_card-addr} remote {"profile-name"}
Example: delete 6 remote "Texas"
The example will delete a remote WAN named "Texas" from the WAN profile
table for the Router in slot 6.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"profile-name"}
The name of the remote WAN profile to delete. This name must be enclosed in quotes, with
a maximum of 12 characters.
delete (router) snmp community
Use the delete (router) snmp community command to delete an SNMP community entry on
the specified Router card.
Syntax: delete {rtr_card-addr} snmp community
{"community-name"} {ip-addr}
Example: delete 2 snmp community "commune" 192.168.100.245
The example will delete the previously added SNMP community named
"commune" from the TSR in slot 2.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"community-name"}
The name of an existing community with a maximum of 12 characters, enclosed in quotes.
{ip-addr}
The IP address of the host that can access the SNMP agent via this community, in the form
of xxx.xxx.xxx.xxx, where xxx is between 0-255. The address "0.0.0.0" allows any host.