Carrier Access Network Device Axxius 800 - Manual (Page 356)

5-256 Axxius 800 - Release 2.2
CLI Commands
status
status (v54)
Use the status (v54) to display the current near-end line status of the V.54 card.
Syntax: status {v54-addr}
Example: status 3:all
The example displays status of all ports (V.54) on slot 3.
> status 3:all
SLOT 3:
Status for V35 PORT 1:
DCD: Low
CTS: Low
DSR: Low
RTS: Low
DTR: Low
BERT: N/A
SLOT 3:
Status for V35 PORT 2:
DCD: Low
CTS: Low
DSR: Low
RTS: Low
DTR: Low
BERT: N/A
{v54-addr}
Display Descriptions
DCD - Data Carrier Detect indicates port is receiving a carrier signal
CTS - Clear to Send indicates port is ready to receive data
DSR - Data Set Ready indicates port is ready to send data
RTS - Request to Send
DTR - Data Terminal Ready
BERT - Bit Error Rate Test
slot The slot number (1-8) that contains the V.54 card
port Port number or range.