Carrier Access Network Device Axxius 800 - Manual (Page 419)

Axxius 800 - Release 2.2 11-5
Single Channel POTS Cards
Built-In Card Handles
Built-In Card Handles
The Single Channel POTS cards are designed with a handle built into the faceplate to
assist in the removal of the card from the chassis. This handle slides out away from the
unit, creating a handle for a more effective grip.
Card Configuration
The Single Channel POTS card can be configured, using CLI commands.
CLI Commands
The following commands are used to configure the POTS cards. For detailed
information on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between channels
l disconnect
Removes a connection created by the connect command
l set (fxsPS or fxsPSM)
To setup the voice channels parameters (rx gain, signal, tx gain).
l show (fxsPS or fxsPSM)
Displays the settings (type, signaling, rx gain, tx gain) for the FXS PS cards.
l status (fxsPS or fxsPSM)
Displays the status (AB bits received, AB bits transmitted, signal, T1
activity, trunk processing) of the specified FXS PS cards.