Carrier Access Network Device Axxius 800 - Manual (Page 332)

5-232 Axxius 800 - Release 2.2
CLI Commands
status
status (ds1)
Use the status (ds1) command to display the current status of a DS1.
Syntax: status {ds1-addr} [performance] [history]
Example: status a:1
SLOT A:
Status for DS1 1:
Receive: Traffic
Transmit: Traffic
Loopback: OFF
Example: status 1:1
SLOT A:
Status for DS1 1:
Receive: Loss of Signal
Transmit: AIS
Loopback: OFF
{ds1-addr}
The Controller DS1 addresses are different on the DS3 and DS1 Controller, however the
DS1 address on the services cards does not change with Controller type (DS3 or DS1).
DS1 Address on a DS3 Controller in the form {slot:port:channel}
slot A for the DS3 Controller card.
port Port number, range or all.
channel Channel number, range or all.
DS1 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in
the form {slot:port}
slot A for the DS1 Controller card (DS1 mode), or 1-8 for service cards.
port Port number, range or all.