Carrier Access Network Device Axxius 800 - Manual (Page 318)

5-218 Axxius 800 - Release 2.2
CLI Commands
show
show (router-wan) static nat address
The show (router-wan) static nat address command displays the current static NAT address
entries for the specified WAN interface.
Syntax: show {rtr_card-addr} {"wan-name"} static nat address
Example: show 5 "LosAngeles" static nat address
> show 5 "RemoteUnit" static nat address
SLOT 5:
WAN Static NAT Address Settings for RemoteUnit:
Total: 0
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
show (router-wan) stp
The show (router-wan) stp command displays the current Spanning Tree Protocol settings for
the specified WAN interface.
Syntax: show {rtr_card-addr} {"wan-name"} stp
Example: show 5 "LosAngeles" stp
> show 5 "LosAngeles" stp
SLOT 5:
WAN Spanning Tree Protocol Settings for LosAngeles:
Spanning Tree: Enabled
Port Cost: 651 seconds
Port Priority: 128 seconds
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.