Carrier Access Network Device Axxius 800 - Manual (Page 259)

Axxius 800 - Release 2.2 5-159
CLI Commands
set
set (router-wan) other
Use the set (router-wan) other command to set the traffic handling of protocols other than IP
or IPX on the specified WAN interface.
Syntax: set {rtr_card-addr} {"wan-name"} other {block|bridge}
Example: set 1 "LosAngeles" other bridge
The example will set the WAN interface named "LosAngeles" in slot 1, to
bridge other protocols.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{block|bridge}
block Set the WAN to block protocols other than IP or IPX.
bridge Set the WAN to bridge protocols other than IP or IPX.