Carrier Access Network Device Axxius 800 - Manual (Page 77)

Axxius 800 - Release 2.2 4-5
Configuration
Basic System Setup
Set Up Security
Use the following commands to set up the security on the Axxius 800.
Set Up IP Addresses for Telnet CLI
Use the following commands to setup Telnet addresses for Command Line Interface
(CLI).
Upgrade the Axxius 800 Software
Use the following commands to determine the Controller software level, then upgrade
the software to the latest version.
Command Description
set user {"user-name"}
level {1-3}
Specify the user name and the security level.
See set user command for details.
set user {"user-name"}
password
Set a password for the user. See set user
command for details.
Command Description
set ethernet ip address
{ip-addr} {mask}
Set the Ethernet IP address, in the
conventional IP address format. See the set
ethernet ip address command for more
details.
set ip gateway {ip-addr} Set the IP gateway, in the conventional IP
address format. See the set ip gateway
command for more details.
Command Description
status equipment Determine the software level. See the status
equipment command for more information.
load tftp {ip-addr} {"file-
name"} (or load xmodem)
Load the new software to the Axxius 800.
See the load tftp and load xmodem
command for more information.