Carrier Access Network Device Axxius 800 - Manual (Page 302)

5-202 Axxius 800 - Release 2.2
CLI Commands
show
show (router) stp
The show (router) stp command displays the current Spanning Tree Protocol settings for the
specified Router card.
Syntax: show {rtr_card-addr} stp
Example: show 5 stp
> show 5 stp
SLOT 5:
Spanning Tree Protocol Settings for Router:
Spanning Tree: Enabled
Bridge Hello Time: 2 seconds
Bridge Max Age: 20 seconds
Bridge Forward Delay: 15 seconds
Bridge Priority: 32768
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
show (router) syslog
The show (router) syslog command displays the current Syslog setup for the Router card.
Syntax: show {rtr_card-addr} syslog
Example: show 5 syslog
> show 5 syslog
SLOT 5:
Syslog Settings for Router:
Syslog: Enabled
Facility: 20
Level: 3
Server IP Address: 192.168.3.3
{rtr_card-addr}
The slot number (1-8) that contains the Router card.